Post by Mathcope on Jun 1, 2016 21:53:38 GMT -5
I have a problem with an clothing item I'm converting. The thing is, everything looks normal and just fine when close to the sim. I assume the LOD 0 is ok. But when getting away from the view, the other lods seem deformed in game. I assume the deformation is cause by the weight?
The item I cloned to import the mesh has a different set of groups in the LOD0,1,2,3. The lod1 has 2 groups, and the 2,3 only one with the hole mesh together. I did this groups based in the mesh I cloned, but still the problem is there.
As you can see, the problem seems to come with the hand.... and it leaves that aweful like throught the entire map.
HERE is the package if someone can take a look.
(You will see that I haven't decimated the mesh, that is because firstly I though the problem was there, but with the exact same weight paint that the lod 0 works, the 1,2,3 seems not to. 
The item I cloned to import the mesh has a different set of groups in the LOD0,1,2,3. The lod1 has 2 groups, and the 2,3 only one with the hole mesh together. I did this groups based in the mesh I cloned, but still the problem is there.
As you can see, the problem seems to come with the hand.... and it leaves that aweful like throught the entire map.
HERE is the package if someone can take a look.
(You will see that I haven't decimated the mesh, that is because firstly I though the problem was there, but with the exact same weight paint that the lod 0 works, the 1,2,3 seems not to. 
. Thank you again