|
Post by mauvemorn on Apr 4, 2021 12:43:18 GMT -5
You should not do anything beside look at step 2....I just showed you where to look to know if the mesh is affected by bones, I’m on the phone and cannot make new pics
once you transfer the weights, use Clean and Limit total, flip normals and join the bracelet with the body, that’s all
|
|
|
Post by nilootwilyy on Apr 4, 2021 13:57:38 GMT -5
Oh...my bad😅 So I redo all of the steps but when I hit flip normals,the bracelet goes through the wrist... imgur.com/a/fUGJvju
|
|
|
Post by mauvemorn on Apr 4, 2021 14:09:46 GMT -5
Once you join them, the bracelet will turn "partially invisible". To prevent this, you need to flip normals before joining the bracelet with the body ( select the bracelet, in edit mode select everything with A, Mesh - Normals - Flip normals ). Join the bracelet with the body, it will go back to its normal shading. If it won't, then undo the joining and flipping of normal and join without doing it.
|
|
|
Post by nilootwilyy on Apr 4, 2021 14:40:06 GMT -5
OK I undo flip normals and join them without it but it's like going through the wrist again... I really don't know what should I do ... In the screenshots I showed what I did in each steps I don't know what am I doing wrong?😞
|
|
|
Post by mauvemorn on Apr 4, 2021 15:01:50 GMT -5
Please re-read what I told you to do again. The purpose of flipping normals was for this to not happen. You undid what I told you to do and this (the mesh going partially see-through) happened.
Just flip the normals and join it with the body, that's all.
|
|
|
Post by nilootwilyy on Apr 4, 2021 15:24:52 GMT -5
|
|
|
Post by mauvemorn on Apr 4, 2021 15:34:45 GMT -5
It looks like this regardless of whether you flip the normals or not? Did you select the whole mesh before flipping them? After you joined them, switch to edit mode, if the bracelet is selected, flip the normals again for the bracelet only. If it is not selected, select a few faces on it, press Ctrl L to select the whole bracelet, flip them
|
|
|
Post by nilootwilyy on Apr 4, 2021 16:06:17 GMT -5
When I flip the normals, it turns out like this. When I don't, it's fine. Yes I selected the whole bracelet Now it looks like this. Is all of the bracelet selected now? Can I flip it again? imgur.com/a/EVvLQCp
|
|
|
Post by mauvemorn on Apr 4, 2021 16:15:05 GMT -5
I am asking what happens after you join it, flipped or unflipped, not what happens after you flip it.
Yes, just flip it.
|
|