|
|
Post by BokchoiJo on Feb 1, 2023 7:33:13 GMT -5
Hello, a black splotch is showing in CAS on my custom cc and only on the left side. (see picture) The texture look fine in Blender & S4S. I checked the UV and nothing seems to overlap. Tried calculating outside normal too in Blender still the same. I'm using Sims4Studio v3.1.6.2 (Wishes), Blender 2.78. Hope someone can help figure this out. Thanks.
|
|
|
|
Post by dissia on Feb 1, 2023 8:28:42 GMT -5
Hey! It seems that you need to close bottom hole different way, cause after deleting it it's fine. Try to extrude bottom verticles, move them a bit down + inside and then close hole so the angle is not that sharp
|
|
|
|
Post by BokchoiJo on Feb 1, 2023 13:19:29 GMT -5
Thanks for the fast reply, deleting the bottom part does remove the splotch. Tried closing the bottom with your suggestion but the splotch is still visible, I'll experiment with different way. Thanks so much.  |
|
|
|
Post by BokchoiJo on Feb 2, 2023 21:49:22 GMT -5
Ok problem solved. I end up deleting the bottom cap, duplicate the main mesh, flip the normal, shrink it a bit to give it an offset, delete unnecessary polygon, and then joining it together. Thanks again for the help. |
|
