|
Post by panthergirlsim on Sept 5, 2017 20:47:55 GMT -5
In this section Part II: "Marking the seams that will allow the mesh to be unwrapped" part 14. I'm not exactly sure where to select it says "... right mouse click on each of the three sections making up one of the inner ring edges." Can you help me, exactly where should I click? Thanks Moderator edit: User is using this tutorial
|
|
|
Post by panthergirlsim on Sept 5, 2017 21:01:49 GMT -5
How do I upload an image here? I can give you a screenshot
|
|
|
Post by panthergirlsim on Sept 10, 2017 18:44:24 GMT -5
Hello someone help us please I want to finish this project. I posted a question on the 5th
|
|
|
Post by Feyona on Sept 10, 2017 20:14:31 GMT -5
|
|
|
Post by panthergirlsim on Sept 12, 2017 14:13:43 GMT -5
I updated my original post with an image, does this help if you don't mind circling where I do the selection. I was working at that area in the very front near the menus at the bottom of the pic.
Thanks again
|
|
|
Post by panthergirlsim on Oct 23, 2017 10:10:17 GMT -5
In this section Part II: "Marking the seams that will allow the mesh to be unwrapped" part 14. I'm not exactly sure where to select it says "... right mouse click on each of the three sections making up one of the inner ring edges." Can you help me, exactly where should I click? Thanks Moderator edit: User is using this tutorial
|
|
|
Post by annabluu on Oct 23, 2017 15:40:34 GMT -5
in this part, it's saying to mark the seams in the tutorial. you need to select the one of the sides of the inner circle and then mark the seam. then do the same on the opposite side of the mesh.
|
|