|
|
Post by spljushka on Sept 26, 2017 3:20:18 GMT -5
Hi, I'm trying to make a new trashcan following Start to Finish Object tutorial. When exporting lod0 I get a warning saying that some of the mesh geometries are not supported by S4Studio and a suggestion to remove them. I tried several EA trashcans, all of them had this message. Is this something I need to worry about? |
|
|
|
Post by MisterS on Sept 26, 2017 5:34:00 GMT -5
It just means you can make trashcans but they will not function as they should in game. I think toilets give the same message.
|
|
|
|
Post by spljushka on Sept 26, 2017 6:11:53 GMT -5
That's bad. Is there any way around it? A trashcan, toilet and toddler's pot are all in my must do list, as well as a stove, sink, bath, fridge and counters. Edit: I saw bakie's tuning tutorials, so I'm thinking, can I take some decorative pot or whatever, create my mesh and recolor according to orangemittens tutorial and then use bakie's tuning tutorial to change the originally decorative item into a trash bin, will this work? Or am I saying something stupid? |
|
|
|
Post by MisterS on Sept 26, 2017 9:30:45 GMT -5
sink, bath, fridge and counters can all be done
As far as Im aware you can still make trashcans, toilets etc and they will still function as such. I believe its the flushing water in the toilet that is causing the message, it must be something in the way trashcans are filled/emptied that does the same. In other words you can make functional toilet, it just wont flush/fill right
|
|
|
|
Post by spljushka on Sept 26, 2017 11:25:44 GMT -5
Thank you, if it is just flushing than it's good, since I'm making a very primitive set.
|
|
