|
|
Post by kitty44 on Jul 8, 2018 21:42:41 GMT -5
Hi, I'd like to add handles to and flatten the bottom part shown of this countertop. Is there any particular way I'd need to UV map them so they are added to the existing texture? Is there anything else I might need to take into consideration? Thank you!   |
|
|
|
Post by orangemittens on Jul 8, 2018 22:03:40 GMT -5
If you wanted, you could duplicate an existing handle and move the duplicate into position. If you did it that way, you would not have to UV map the item, although you may have to fiddle with it a bit when doing your bake or move it to another part of the map and then copy/paste the handle texture in the correct position.
|
|
|
|
Post by kitty44 on Jul 9, 2018 4:14:35 GMT -5
If you wanted, you could duplicate an existing handle and move the duplicate into position. If you did it that way, you would not have to UV map the item, although you may have to fiddle with it a bit when doing your bake or move it to another part of the map and then copy/paste the handle texture in the correct position. Thanks! I'll give this a try. |
|
