|
Post by mel0nberry on Jul 9, 2021 16:57:54 GMT -5
Hey all (me again hehe), I converted a S3 object to S4 using this tutorial. Everything looks good and works in my game, however... it still has the slot leftover from the pedestal used as a base mesh. As seen, the mesh has the slot from the pedestal. Is there any way to get rid of this? It isn't a nuisance but I KINDA want to get rid of it, if possible :p Thank you in advance! (:
|
|
|
Post by menaceman44 on Jul 11, 2021 14:53:43 GMT -5
You should be able to remove it by going to the Rig/Slot tab in Studio, selecting the slot you don't want, and using the Remove or Delete option. Make sure to create a backup of your file first though just in case anything goes wrong.
|
|
|
Post by mel0nberry on Jul 22, 2021 15:19:16 GMT -5
You should be able to remove it by going to the Rig/Slot tab in Studio, selecting the slot you don't want, and using the Remove or Delete option. Make sure to create a backup of your file first though just in case anything goes wrong. Thank you so much!!!
|
|
|
Post by Fwecka (Lolabellesims) on Jul 23, 2021 5:35:16 GMT -5
If it's just a decor item don't clone the pedestal. That tutorials says to do this but, if I'm not mistaken, the pedestal didn't use to have a slot. I might be wrong on that, however. Generally, if it's a small decor item that sits on a table, I clone the stack of books. That tutorial is pretty outdated, I'm afraid. You'll find better tutorials on this site.
|
|