|
Post by simguy80 on May 26, 2019 12:42:15 GMT -5
1. Select the Studio tab at the top. 2. Select the Rig/Slots tab to the right 3. Select _noBind_customHolder_E_ from the list below 4. In the X: position, reverse the number. (If it's positive use -, if negative remove the -) 5. Save
BTW, I was trying to figure out if there's a way to change which way the door swings in and out, but I had no luck. (It currently is pulled when knob is on the right.) Maybe someone can enlighten me if that can be done (without using Blender)?
|
|